Extreme Networks ExtremeWare - Configure Qosprofile Wanqos Maxbuf

configure qosprofile wanqos maxbuf
ExtremeWare Software 7.3.0 Command Reference Guide 1717
configure qosprofile wanqos maxbuf
configure qosprofile <qosprofile> wanqos maxbuf <count> [ports <portlist> |
multilink
<multilink name>]
Description
Sets the maximum queue depth for for T1 and E1 modules.
Syntax Description
Default
By default, 256 packet buffers are assigned to the high priority queue.
Usage Guidelines
This command sets the software egress queue buffers for T1 and E1 modules.
For WAN QoS, each port has 256 packet buffers of 1900 bytes. The buffers are shared among the eight
queues. Use a small number for low latency. Use a large number for best effort on bursty traffic
Example
The following command configures the QoS maximum buffer of QoS profile qp5 to 128 for ports 2:1 and
2:3:
configure qosprofile qp5 wanqos maxbuf 128 ports 2:1,2:3
History
This command was available in ExtremeWare 7.1.0.
Platform Availability
This command is available for T1 and E1 modules.
qosprofile Specifies a QoS profile name.
count Specifies a maximum buffer size this queue. The default setting is 0.
portlist Specifies a list of ports or slots and ports to which the parameters apply. May
be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
multilink name Specifies a multilink.