Extreme Networks ExtremeWare - Enable Log Display

enable log display
ExtremeWare Software 7.3.0 Command Reference Guide 693
enable log display
enable log display
Description
Enables a running real-time display of log messages on the console display.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
If you enable the log display on a terminal connected to the console port, your settings will remain in
effect even after your console session is ended (unless you explicitly disable the log display).
You configure the messages displayed in the log using the configure log display , or configure log
target console-display commands.
In ExtremeWare 7.1.0, the ability to control logging to different targets was introduced. The new
command equivalent to
enable log display is the following:
enable log target console-display
To change the log filter association, severity threshold, or match expression for messages sent to the
console display, use the
configure log target console-display command
Example
The following command enables a real-time display of log messages:
enable log display
History
This command was first available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.