configure mpls vpls peer
ExtremeWare Software 7.3.0 Command Reference Guide 1973
configure mpls vpls peer
config mpls vpls <vpls_name> peer [<ipaddress> | <host_name>] [add |
delete] [lsp <lsp_name>]
Description
Configures additional LSPs to a VPLS peer.
Syntax Description
Default
N/A.
Usage Guidelines
This command configures additional LSPs to a VPLS peer. The
add
keyword may be used to add up to
four RSVP-TE LSPs to the VPLS peer. Traffic to the VPLS peer is aggregated across all configured LSPs.
LSP traffic aggregation is described in Equal-cost Multipath LSP Support on page 3. The
delete
keyword will remove the LSP specified by the
lsp_name
parameter from the VC-LSP aggregation list. If
all the LSPs are deleted, the VC-LSP will attempt to use the best-routed path LSP, if one exists. If no
LSPs exist to the VPLS peer, VPN connectivity to the VPLS peer is lost.
Example
None.
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch.
vpls_name Identifies the VPLS within the switch (character string)
ipaddress Specifies the IP address for the peer node that is the endpoint of the VC-LSP
host_name Specifices the peer host name.
add
Permits addition of up to four RSVP-TE LSPs to the VPLS peer.
delete Removes the LSP specified by the lsp_name parameter from the VC-LSP
aggregation list.
lsp_name Removes the specified lsp.
To Next Page
Loading...