configure bootprelay delete
ExtremeWare Software 7.3.0 Command Reference Guide 1147
configure bootprelay delete
configure bootprelay delete [<ip address> | all]
Description
Removes one or all IP destination addresses for forwarding BOOTP packets.
Syntax Description
Default
N/A.
Usage Guidelines
After IP unicast routing has been configured, you can configure the switch to forward Dynamic Host
Configuration Protocol (DHCP) or BOOTP requests coming from clients on subnets being serviced by
the switch and going to hosts on different subnets. To configure the relay function, follow these steps:
1 Configure VLANs and IP unicast routing.
2 Enable the DHCP or BOOTP relay function, using the following command:
enable bootprelay
3 Configure the addresses to which DHCP or BOOTP requests should be directed, using the following
command:
configure bootprelay add <ip address>
Example
The following command removes the destination address:
configure bootprelay delete 123.45.67.8
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
all Specifies all IP address entries.
To Next Page
Loading...