Extreme Networks ExtremeWare - Show Ports Info

show ports info
ExtremeWare Software 7.3.0 Command Reference Guide 1745
show ports info
show ports {mgmt | <portlist>} [t1 | e1 | t3] info
Description
Displays the port configuration and status.
Syntax Description
Default
N/A.
Usage Guidelines
If you do not specify a port number or range of ports, information is displayed for all ports.
Example
The following command displays the T1 information for a single port:
show ports 4:2 t1 info
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
E1 support was added in ExtremeWare v6.1.8w3.0.1b56 WAN technology release.
T3 support was added in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
mgmt Specifies the management port. Supported only for switches that provide a
management port.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.