Extreme Networks ExtremeWare User Manual

configure mpls ldp acl
ExtremeWare Software 7.3.0 Command Reference Guide 1945
configure mpls ldp acl
config mpls ldp acl [enabled | disabled]
Description
Enables or disables an MPLS LDP Access Control List (ACL).
Syntax Description
Default
N/A.
Usage Guidelines
This command enables or disables an MPLS LDP Access Control List (ACL). The enabled keyword
specifies that the ACL be enabled. When enabled, all required authentication procedures are enforced.
LDP ACLs cannot be enabled unless at least one LDP ACL peer has been configured. The disabled
keyword specifies that the ACL be disabled. No authentication procedures are enforced. LDP ACLs
must be disabled before all LDP ACL peers can be deleted. Changing the ACL enabled configuration
may result in the termination of sessions or services with peers that cannot be validated. The LDP ACL
status is displayed using the show mpls command.
Example
None.
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch.
enabled Enables MPLS LDP ACL such that all required authentication procedures are
enforced.
disabled Disables MPLS LDP ACL.

Extreme Networks ExtremeWare Specifications

General

Vendor	Extreme Networks
Compatibility	Extreme Networks switches and routers
Type	Network Operating System
Functionality	Network management
User Interface	CLI
Protocols Supported	OSPF, BGP, RIP, VLAN, STP
Features	QoS, Security Features