configure eaps mode
ExtremeWare Software 7.3.0 Command Reference Guide 979
configure eaps mode
configure eaps <name> mode [master | transit]
Description
Configures the switch as either the EAPS master node or as an EAPS transit node for the specified
domain.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
The following command identifies this switch as the master node for the domain named eaps_1:
configure eaps eaps_1 mode master
The following command identifies this switch as a transit node for the domain named eaps_1:
configure eaps eaps_1 mode transit
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on the “i” series platforms.
name Specifies the name of an EAPS domain.
master Specifies that this switch should be the master node for the named EAPS
domain.
transit Specifies that this switch should be the transit node for the named EAPS
domain.
To Next Page
Loading...