676 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
disable log target
disable log target [console-display | memory-buffer | nvram | session |
syslog [<host name/ip> {:<udp-port>} [local0 ... local7]]]
Description
Stop sending log messages to the specified target.
Syntax Description
Default
Enabled, for memory buffer and NVRAM; all other targets are disabled by default.
Usage Guidelines
This command stops sending messages to the specified target. By default, the memory buffer and the
NVRAM targets are enabled. Other targets must be enabled before messages are sent to those targets.
Configuration changes to the
session
target are in effect only for the duration of the console display or
telnet session, and are not saved in FLASH. Changes to the other targets are saved to FLASH.
In earlier versions of ExtremeWare, a similar command was used to disable displaying the log on the
console. That command:
disable log display
is equivalent to:
disable log target console-display
Example
The following command disables log messages to the current session:
disable log target session
History
This command was first available in ExtremeWare 7.1.0.
console-display Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
host name/ip Specifies the syslog host name or IP address.
udp-port Specifies the UDP port number for the syslog target.
local0 ... local7 Specifies the local syslog facility.
To Next Page
Loading...