Extreme Networks ExtremeWare - Show Wireless Ap-Scan Results

show wireless ap-scan results
ExtremeWare Software 7.3.0 Command Reference Guide 2069
show wireless ap-scan results
show wireless ap-scan results {detail}
Description
Displays a switch-wide, correlated view of the results of the access point (AP) scan.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to see the results of an AP scan. Use the optional keyword, detail , to see all of the
fields in
Table 33.
Example
The following command displays information about the AP scan.
show wireless ap-scan results
detail This optional keyword, provides more in-depth information.
Table 33: AP Scan Results (Alphabetized)
Data Value Description
APMAC MAC address of the discovered AP
Capability Capability field from a received information packet (in detail
output only)
Channel The channel on which this AP was discovered
ESS Name String ESS ID I.E.
Last Change Time value at which this entry was updated
Min/Max/Avg RSS Received Signal Strength statistics
Network Type Ad-hoc or BSSID network (in detail output only)
Number of beacons Count of beacon packets seen from this AP (in detail output only)
Number of probe resp Count of PROBE RESP packets sent from the AP (in detail
output only)
Supported Rate Set List of supported rates
WEP required/WEP authentication supported WEP information from beacon and probe packets
WPA WPA information, including authentication and supported
encryption algorithms
First Seen First discovered.