1620 ExtremeWare Software 7.3.0 Command Reference Guide
ATM Commands
configure atm delete pvc
configure atm delete pvc [<vpi / vci> | all] {vlan <vlan name>} ports
<portlist>
Description
This command is used to delete a PVC configuration on an ATM port.
Syntax Description
Default
None.
Usage Guidelines
This command deletes the specified PVC configuration on the specified ATM port(s). The optional
vlan
parameter may be used to limit the scope of the command to the specified VLAN. The PVC may still
exist following command execution if multiple VLANs have been configured to use the PVC. If the
vlan
parameter is omitted, the PVC configuration is deleted for all VLANs on the specified ATM
port(s).
The command can be used to delete configuration information for the PVC identified via the
vpi
and
vci
parameters for all PVCs defined for the specified VLAN(s) or port(s). The
all
keyword may be
used as either a portlist parameter to indicate that the command should be applied to all ATM ports or
all PVCs. A PVC is completely deleted when there are no longer any VLANs configured for the PVC on
a given ATM port.
NOTE
All associated PVCs must be deleted before an ATM port can be removed from a VLAN.
Example
The following command deletes the specified PVC configuration on ATM port 1:1 on a VLAN named
accounting
.
configure atm delete pvc 5/102 encap l2 vlan accounting port 1:1
vpi Specifies the VPI parameter as an integer.
The valid VPI range is from 0 to 15.
vci Specifies the VCI parameter as an integer.
The valid VCI range is from 17 to 4095
all Specifies all ATM ports or all PVCs.
vlan name Specifies a VLAN name.
portlist Specifies list of ports or slots and ports. May be in the form 1, 2, 3-5,
2:5, 2:6-2:8.
To Next Page
Loading...