configure iparp add
ExtremeWare Software 7.3.0 Command Reference Guide 1153
configure iparp add
configure iparp add <ip address> <mac_address>
Description
Adds a permanent entry to the ARP table. Specify the IP address and MAC address of the entry.
Syntax Description
Default
N/A.
Usage Guidelines
Add a permanent IP ARP entry to the system. The
ip address
is used to match the IP interface
address to locate a suitable interface.
Example
The following command adds a permanent IP ARP entry to the switch for IP address 10.1.2.5:
configure iparp add 10.1.2.5 00:11:22:33:44:55
History
This command was available in ExtremeWare 2.0.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
mac_address Specifies a MAC address.
To Next Page
Loading...