Extreme Networks ExtremeWare - Enable Bgp Neighbor

1468 ExtremeWare Software 7.3.0 Command Reference Guide
BGP Commands
enable bgp neighbor
enable bgp neighbor [<ip address> | all]
Description
Enables the BGP session. The neighbor must be created before the BGP neighbor session can be enabled.
Syntax Description
Default
Disabled.
Usage Guidelines
To create a new neighbor and add it to a BGP peer group, use the following command:
create bgp neighbor <ip address> peer-group <peer group> {multi-hop}
Example
The following command enables the BGP neighbor session:
enable bgp neighbor 192.168.1.17
History
This command was available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
ip address Specifies an IP address.
all Specifies all neighbors.