configure ports link-detection-level
ExtremeWare Software 7.3.0 Command Reference Guide 245
configure ports link-detection-level
configure ports <portlist> link-detection-level <link-detection-level>
Description
Configures the link detection level.
Syntax Description
Default
The default link detection level is 2.
Usage Guidelines
The range is 1 - 4. Table 9 lists the behavior of the switch at each level.
Example
The following command configures the link detection level for port 3 to 4:
configure ports 3 link-detection-level 4
History
This command was first available in ExtremeWare 6.2.2.
Platform Availability
This command is available on all platforms.
portlist Specifies one or more primary ports or slots and ports. On a modular switch, can be a list
of slots and ports. On a stand-alone switch, can be one or more port numbers. May be in
the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
link-detection-level Specifies a link detection level.
Table 9: Link detection level behavior
Level ISR Middle Layer Filter
1 off off
2 on off
3 off on
4 on on
To Next Page
Loading...