1188 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
disable icmp address-mask
disable icmp address-mask {vlan <vlan name>}
Description
Disables the generation of an ICMP address-mask reply on one or all VLANs.
Syntax Description
Default
Enabled.
Usage Guidelines
Disables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask
request is received. The default setting is enabled. If a VLAN is not specified, the command applies to
all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command disables the generation of an ICMP address-mask reply on VLAN accounting:
disable icmp address-mask vlan accounting
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
To Next Page
Loading...
Need help?
General
