1352 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
enable isis ignore-attached-bit
enable isis ignore-attached-bit
Description
Enables ignoring the attached bit.
Syntax Description
This command has no arguments or variables.
Default
The default setting is disabled.
Usage Guidelines
This command can only be applied to a level 1 only switch. It specifies that the level 1 only switch will
ignore the attached bit (ATT bit) from level 1/2 switches.
This command has the effect of disabling the feature described in the ExtremeWare Software User Guide,
Software Version 7.0.0, in the chapter, “Interior Gateway Protocols”, in the section, “Default Routes to
Nearest Level 1/2 Switch for Level 1 Only Switches”. See the user guide for more information.
Example
The following command enables ignoring the attached bit:
enable isis ignore-attached-bit
History
This command was first available in ExtremeWare v6.1.8 IS-IS tech release and subsequently
incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...
Need help?
General
