configure nat icmp-timeout
ExtremeWare Software 7.3.0 Command Reference Guide 427
configure nat icmp-timeout
configure nat icmp-timeout <seconds>
Description
Configures the timeout for an ICMP packet.
Syntax Description
Default
Default timeout is 3 seconds.
Usage Guidelines
Setting the timeout to zero specifies that session table entries should not be timed-out. This is not
normally recommended as NAT resources will get used up.
Example
The following command configures the timeout for an ICMP packet to 5 seconds:
configure nat icmp-timeout 5
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
seconds Specifies the number of seconds to wait before the session table entry times
out.
To Next Page
Loading...
Need help?
General
