Extreme Networks ExtremeWare - Unconfigure Switch

unconfigure switch
ExtremeWare Software 7.3.0 Command Reference Guide 2125
unconfigure switch
unconfigure switch {all} {enhanced}
Description
Returns the switch configuration to its factory default settings.
Syntax Description
Default
Resets configuration to factory defaults without reboot.
Usage Guidelines
Use unconfigure switch to reset the configuration to factory defaults, but without erasing the
configuration and rebooting. This preserves users account information such as date and time settings.
Include the parameter all to clear the entire current configuration, including all switch parameters, and
reboot using the last used image and configuration.
Include the parameter enhanced to clear the entire current configuration, with the exception of the
default configuration mode, which will be set to enhanced. In enhanced mode, the switch boots with all
ports disabled. If the
enhanced parameter is not entered, the default configuration mode will be reset to
the standard mode, in which the switch boots with all ports in forwarding mode. To configure the
default startup configuration for the switch, use the
configure configuration-mode command.
NOTE
After using the unconfigure switch all command, the show configuration output displays the VLAN
default without any ports assigned. The ports still belong to the VLAN default, as the show vlan output
correctly displays.
Example
The following command erases the entire current configuration, resets to factory defaults, and reboots
the switch using the last specified saved image and saved configuration:
unconfigure switch all
History
This command was available in ExtremeWare 2.0.
This command was modified to include the enhanced parameter in ExtremeWare 7.3.0.
all Specifies that the entire current configuration should be erased, and the switch
rebooted.
enhanced Specifies that the entire current configuration should be erased with the
exception of the default configuration mode, which will be set to enhanced. In
enhanced mode, the switch boots with all ports disabled.