configure wireless ports interface ap-scan probe-interval
ExtremeWare Software 7.3.0 Command Reference Guide 2015
configure wireless ports interface ap-scan probe-interval
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
probe-interval <msec>
Description
Use this command to configure the interval between probe request packets for active off-channel
scanning.
Syntax Description
Default
100 ms.
Usage Guidelines
Use this command to send probe requests at particular intervals on a selected channel during an access
point (AP) scan.
Example
The following example configures the interval between probe request packets to be 10 ms for port 1:9
on interface 2:
configure wireless ports 1:9 interface 2 ap-scan probe-interval 10
History
This command was first available in ExtremeWare 6.2a and added to the “i” series in 7.3.0.
Platform Availability
This command is available on Alpine 3800 series only.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
msec Specifies the time between probe request packets in milliseconds. Valid
entries are between 50 and 3600000 milliseconds.
To Next Page
Loading...
Need help?
General
