Extreme Networks ExtremeWare - Configure Debug-Trace Ipxsap-Message

configure debug-trace ipxsap-message
ExtremeWare Software 7.3.0 Command Reference Guide 2165
configure debug-trace ipxsap-message
configure debug-trace ipxsap-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for IPX SAP message errors to 3:
configure debug-trace ipxsap-message 3
Following is the log output at this level:
<INFO:USER> admin logged in through console
<DBUG:XSAP> Generating SAP query (opcode=0001, svc type=ffff)
<INFO:SYST> Port 2:1 link active 100Mbs FULL duplex
<INFO:SYST> Port 2:1 link down
<INFO:SYST> User admin logged out from console
<INFO:SYST> Log cleared
<INFO:SYST> serial admin: clear log
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
debug level Specifies a debug level:
0 — None.
1 — None.
2 — Verifies that IPX SAP messages are being sent and received.
3 — Verifies the contents of the messages.
4 — Displays a dump of each packet.
5 — No additional information recorded.
vlan name Specifies a VLAN name.