990 ExtremeWare Software 7.3.0 Command Reference Guide
EAPS Commands
show eaps
show eaps {<name>} {detail}
Description
Displays EAPS status information.
Syntax Description
Default
N/A.
Usage Guidelines
If you enter the
show eaps
command without a keyword, the command displays less than with the
detail
keyword.
Use the optional domain name parameter to display status information for a specific EAPS domain.
The output displayed by this command depends on whether the node is a transit node or a master
node. The display for a transit node contains information fields that are not shown for a master node.
Also, some state values are different on a transit node than on a master node.
The fields displayed are as follows:
name Specifies the name of an EAPS domain.
detail Specifies all available detail for each domain.
EAPS Enabled: Current state of EAPS on this switch:
• Yes—EAPS is enabled on the switch.
• No—EAPS is not enabled.
EAPS Fast Convergence: Displays only when Fast Convergence is on.
Number of EAPS instances: Number of EAPS domains created. The maximum number of EAPS domains
per switch is 64.
EAPSD-Bridge links: The total number of EAPS bridge links in the system. The maximum count is
8192. Each time a VLAN is added to EAPS, this count increments by 1.
Name: The configured name for this EAPS domain.
(instance= ) The instance number is created internally by the system.
To Next Page
Loading...