Extreme Networks ExtremeWare - Configure Debug-Trace Ipxrip-Message

configure debug-trace ipxrip-message
ExtremeWare Software 7.3.0 Command Reference Guide 2161
configure debug-trace ipxrip-message
configure debug-trace ipxrip-message <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
Default
The default level is 0.
Usage Guidelines
The debug level range is 0 to 5. Higher levels record more verbose messages. Higher levels also record
the messages recorded at lower levels.
Example
The following command sets the reporting level for IPX RIP message errors to 4:
configure debug-trace ipxrip-message 4
Following is the log output at this level:
<INFO:SYST> serial admin: configure debug-trace ipxrip-message 4 ipxvlan
<INFO:SYST> Log cleared
<INFO:SYST> serial admin: clear log
<DBUG:KERN> 0x0881347d82: 00 03 **
<DBUG:KERN> 0x0881347d72: 00 02 00 00 36 12 00 01 00 01 00 00 10 69 00 02
****6********i**
<DBUG:XRIP> Sending Rsp msg to f0001964:ff:ff:ff:ff:ff:ff len 18
<DBUG:XRIP> Added entry net 1069 hops 2 ticks 3 to rsp
<DBUG:XRIP> Added entry net 3612 hops 1 ticks 1 to rsp
<INFO:EAPS> eaps_runtime.c 1426: State Change, Failed -> Complete, EAPS="man1"
<INFO:EAPS> eaps_runtime.c 277: Primary Port Change, Down -> Up
<INFO:SYST> Port 1:2 link active 1000Mbs FULL duplex
<DBUG:KERN> 0x0881347d82: 00 03 **
<DBUG:KERN> 0x0881347d72: 00 02 00 00 36 12 00 01 00 01 00 00 10 69 00 02
****6********i**
<DBUG:XRIP> Sending Rsp msg to f0001964:ff:ff:ff:ff:ff:ff len 18
debug level Specifies a debug level:
0 — None.
1 — None.
2 — Verifies that ipxrip messages are being sent and received.
3 — Verifies the contents of the messages.
4 — Displays a dump of each packet.
5 — No additional information recorded.
vlan name Specifies a VLAN name.