876 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
disable netlogin
disable netlogin [web-based |dot1x]
Description
Disables Network Login modes.
Syntax Description
Default
Both types of authentication are enabled.
Usage Guidelines
Both types, either type, or no type of authentication can be enabled on the same switch. To enable an
authentication mode, use the following command:
enable netlogin [web-based | dot1x]
This command was first introduced as
disable netlogin
, which disabled the initial version of
Network Login, the web-based mode. The original command was subsequently deprecated when the
802.1x mode of Network Login was introduced in ExtremeWare 7.1.0. The deprecated version of the
command is temporarily supported in configurations. During an upgrade, the deprecated command:
disable netlogin
will be interpreted as:
disable netlogin web-based
disable netlogin dot1x
Example
The following command disables Network Login:
disable netlogin
History
The
web-based
and
dot1x
keywords were added in ExtremeWare 7.1.0, and the initial version of the
command (without the new keywords) was deprecated.
This command was first available in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
web-based Specifies web-based authentication.
dot1x Specifies 802.1x authenticating.
To Next Page
Loading...