enable ports
ExtremeWare Software 7.3.0 Command Reference Guide 273
enable ports
enable ports [<portlist> | all]
Description
Enables a port.
For PoS modules, enables the PPP link on the specified port, and changes the port status LED to solid
green (if no other problems exist).
Syntax Description
Default
All ports are enabled.
Usage Guidelines
Use this command to enable the port(s) if you disabled the port(s) for security, administration, or
troubleshooting purposes.
On a modular switch,
<portlist>
can be a list of slots and ports. On a stand-alone switch,
<portlist>
can be one or more port numbers. For a detailed explanation of port specification, see
“Modular Switch
Numerical Ranges” or “Stand-alone Switch Numerical Ranges” in Chapter 1.
Example
The following command enables ports 3, 5, and 12 through 15 on the stand-alone switch:
enable ports 3,5,12-15
The following command enables slot 1, ports 3, 5, and 12 through 15 on the modular switch:
enable ports 1:3, 1:5, 1:12-1:15
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 6.1 to support PoS modules.
This command was modified in ExtremeWare 4.0 to support the modular switches.
Platform Availability
This command is available on all platforms.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all ports on the switch.
To Next Page
Loading...
Need help?
General
