show slb failover
ExtremeWare Software 7.3.0 Command Reference Guide 583
show slb failover
show slb failover
Description
Displays SLB failover configuration and status.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
The
show slb global
command also displays SLB failover configuration and status.
Example
The following command displays the current SLB failover configuration and status:
show slb failover
Following is the output from this command:
SLB Failover Configuration:
Failover: Enabled
Local unit ID: 1
Local IP address: 10.1.1.1
Remote IP address: 10.1.1.2
TCP port number: 1028
Remote Alive frequency: 1
Remote Dead frequency: 2
Keepalive Timeout: 3
Ping check: Disabled
Ping check IP address: 0.0.0.0
Ping frequency: 1
Ping timeout: 3
Manual failback: Disabled
#
#
SLB Failover Status: Running
Units active in local SLB: 2
Units active in or
requested by remote SLB: None
Send connection: Down
Receive connection: Down
Ping check: Not Running
To Next Page
Loading...