configure pim add vlan
ExtremeWare Software 7.3.0 Command Reference Guide 1507
configure pim add vlan
configure pim add vlan [<vlan name> | all] {dense | sparse}
Description
Enables PIM on an IP interface.
Syntax Description
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
configure pim add vlan accounting dense
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
dense Specifies PIM dense mode (PIM-DM).
sparse Specifies PIM sparse mode (PIM-SM).
To Next Page
Loading...
Need help?
General
