configure eaps port
ExtremeWare Software 7.3.0 Command Reference Guide 981
configure eaps port
configure eaps <name> [primary | secondary] port
<port
number>
Description
Configures a node port as the primary or secondary port for the specified EAPS domain.
Syntax Description
Default
N/A.
Usage Guidelines
Each node on the ring connects through two ring ports. One port must be configured as the primary
port; the other must be configured as the secondary port.
Example
The following command adds port 1 of the module installed in slot 8 of a BlackDiamond switch to the
EAPS domain “eaps_1” as the primary port:
configure eaps eaps_1 primary port 8:1
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on the “i” series platforms.
name Specifies the name of an EAPS domain.
primary Specifies that the port is to be configured as the primary port.
secondary Specifies that the port is to be configured as the secondary port.
port number Specifies the port number.
To Next Page
Loading...
Need help?
General
