Extreme Networks ExtremeWare - Configure Cpu-Dos-Protect Trusted-Ports

configure cpu-dos-protect trusted-ports
ExtremeWare Software 7.3.0 Command Reference Guide 781
configure cpu-dos-protect trusted-ports
configure cpu-dos-protect trusted-ports [add <port number> | delete <port
number> | all | none]
Description
Configures ports as trusted, so that denial of service protection is not applied to port.
Syntax Description
Default
By default, no ports are trusted.
Usage Guidelines
Typically, you would use the all parameter when you want to set the denial of service protection to
only a few of the ports on a switch. Use the
all parameter, then use the command configure
cpu-dos-protect trusted-ports delete <port number>
to set ports that should not be trusted
(that denial of service protection should be applied to).
Example
The following command configures a port as trusted, so that denial of service protection is not applied
to port 3:
configure cpu-dos-protect trusted-port add 3
History
This command was first available in ExtremeWare 7.0.0
Platform Availability
This command is available on all platforms.
port number Specifies a port.
all Specifies all ports as trusted.
none Specifies that no ports are trusted.