Extreme Networks ExtremeWare User Manual

1656 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
configure ppp pos checksum ports
configure ppp pos checksum [32 | 16] ports <portlist>
Description
Configures the size of the HDLC Frame Check Sequence (FCS) to be used on the specified SONET
ports.
Syntax Description
Default
The default is a 32-bit FCS.
Usage Guidelines
The two choices are a 32-bit FCS or a 16-bit FCS. RFC 2615 recommends that a 32-bit FCS be used.
Example
The following command example sets the FCS to 16 for port 1 of the PoS module installed in slot 8 of
the BlackDiamond switch:
config ppp pos checksum 16 ports 8:1
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
16 or 32 Specifies the size of the HDLC frame check sequence (either 32 bits or 16
bits).
portlist Specifies the port number(s).

Extreme Networks ExtremeWare Specifications

General

Brand	Extreme Networks
Model	ExtremeWare
Category	Software
Language	English