2084 ExtremeWare Software 7.3.0 Command Reference Guide
Wireless Commands
show wireless ports interface client-history mac-layer
show wireless ports [<portlist> | all] interface [1 | 2] client-history
mac-layer <mac_address>
Description
Displays 802.11 MAC layer information collected on a per-client basis.
Syntax Description
Default
N/A.
Usage Guidelines
Use this command to display information on the operation of the 802.11 MAC layer.
Example
The following example displays client-history information for port 1:25 and interface 1 based on the
MAC address of the client:
show wireless ports 1:25 interface 1 client-history mac-layer 00:0D:54:98:AC:35
The output of the command is similar to:
Intf : 1:25:1
AP Mac address : 00:0D:54:98:AC:35
Authentication Information
Authenticated : Y
Total AUTH REQ : 1
Total AUTH RESP : 1
Total AUTH OK : 1
Total AUTH Failed : 0
Total AUTH (open) : 0
Total AUTH (shared) : 1
Last AUTH REQ : 19:40:06
Last Auth Type : OPEN
Authentication Error Information
Last Error Time : 00:00:00
Last Error Type : NONE
Errors by Type
Sequence Number : 0
Challenge Text (key) : 0
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
mac_address Specifies the MAC address of the wireless client.
To Next Page
Loading...