1492 ExtremeWare Software 7.3.0 Command Reference Guide
IP Multicast Commands
configure dvmrp vlan timer
configure dvmrp vlan <vlan name> timer <probe interval> <neighbor timeout>
Description
Configures DVMRP interface timers.
Syntax Description
Default
The probe interval default setting is 10 seconds. The neighbor timeout default setting is 35 seconds.
Usage Guidelines
Specify the following:
• probe interval—The amount of time that the system waits between transmitting DVMRP probe
messages. The range is 1 to 2,147,483,647 seconds (68 years). The default setting is 10 seconds.
• neighbor timeout—The amount of time before a DVMRP neighbor router is declared to be down.
The range is 1 to 2,147,483,647 seconds (68 years). The default setting is 35 seconds
(3.5
* probe interval).
Example
The following command configures the DVMRP timers:
configure dvmrp vlan accounting timer 3000 9000
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
probe interval Specifies the time in seconds between probe messages.
neighbor timeout Specifies the time in seconds before a neighbor router is declared to be down.
To Next Page
Loading...