2122 ExtremeWare Software 7.3.0 Command Reference Guide
Configuration and Image Commands
show configuration
show configuration [detail]
Description
Displays the currently active configuration to the terminal.
Syntax Description
Usage Guidelines
If the output scrolls off the top of the screen, you can use the
enable clipaging
command to pause the
display when the output fills the screen. The default for clipaging is enabled.
NOTE
After using the unconfigure switch all command, the show configuration output displays the VLAN
default without any ports assigned. The ports still belong to the VLAN default, as the show vlan output
correctly displays.
Example
This command shows the current configuration active in the switch:
show configuration detail
History
This command was available in ExtremeWare 2.0.
This command was modified to show the auto-negotiation status of Gigabit Ethernet ports in
ExtremeWare 6.2.2.
Platform Availability
This command is available on all platforms.
detail Specifies to show all configuration statements including default commands.
To Next Page
Loading...
Need help?
General
