Extreme Networks ExtremeWare - Configure Snmp Delete Trapreceiver

configure snmp delete trapreceiver
ExtremeWare Software 7.3.0 Command Reference Guide 121
configure snmp delete trapreceiver
configure snmp delete trapreceiver [{<ip address> {port <number>}} | {all}]
Description
Deletes a specified trap receiver or all authorized trap receivers.
Syntax Description
Default
The default port number is 162.
Usage Guidelines
Use this command to delete a trap receiver of the specified IP address, or all authorized trap receivers.
Beginning in ExtremeWare 7.1.0, this command deletes only the first SNMPv1/v2c trap receiver whose
IP address and port number match the specified value.
If a trap receiver has been added multiple times with different community strings, the community
option specifies that only the trap receiver entry with the specified community string should be
removed.
Example
The following command deletes the trap receiver 10.101.0.100 from the trap receiver list:
configure snmp delete trapreceiver 10.101.0.100
The following command deletes entries in the trap receiver list for 10.101.0.100, port 9990:
configure snmp delete trapreceiver 10.101.0.100 port 9990
Any entries for this IP address with a different community string will not be affected.
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 6.2.1 to support the community option.
This command was modified in ExtremeWare 7.1.0 for SNMPv3 compatibility.
Platform Availability
This command is available on all platforms.
ip address Specifies an SNMP trap receiver IP address.
port <number> Specifies the port associated with the receiver.
all Specifies all SNMP trap receiver IP addresses.