1216 ExtremeWare Software 7.3.0 Command Reference Guide
IP Unicast Commands
enable icmp redirects
enable icmp redirects {vlan <vlan name>}
Description
Enables generation of ICMP redirect messages on one or all VLANs.
Syntax Description
Default
Enabled.
Usage Guidelines
This option only applies to the switch when the switch is not in routing mode.
Example
The following command enables the generation of ICMP redirect messages on all VLANs:
enable icmp redirects
History
This command was available in ExtremeWare 2.0.
This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare
v6.1.8b12 to support MPLS modules.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
To Next Page
Loading...