show sflow configuration
ExtremeWare Software 7.3.0 Command Reference Guide 739
show sflow configuration
show sflow configuration
Description
Displays the current sFlow configuration.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays all sFlow configuration information for the switch.
The following fields are displayed:
• Global Status—sFlow is globally enabled or disabled.
• Polling interval—How often data from each sampler is sent to the collector, in seconds.
• Sampling rate—Packets are sampled, on average, once for every rate-number of packets.
• BackOff Threshold—Enabled or disabled. Used to limit the number of packets sent to the collector in
a second.
• BackOff Threshold (No. of Samples)—Configured threshold used to limit the number of packets sent
to the collector in a second.
• Configured Agent IP—IP address of the operational sFlow agent.
• Collectors—Collected packet samples will be sent to this list of collector addresses.
• SFLOW Port Configuration: Port—List of all ports with sFlow enabled.
• SFLOW Port Configuration: Status—Enabled or disabled for statistics gathering.
Example
To display the sFlow configuration on your system, use the following command:
show sflow
The output from this command is similar to the following:
SFLOW Global Configuration
Global Status: enabled
Polling interval: 30
Sampling rate: 512
BackOff Threshold: disabled
BackOff Threshold (No. of Samples): 50
SFLOW Configured Agent IP: 10.201.6.100
To Next Page
Loading...