show system-dump
ExtremeWare Software 7.3.0 Command Reference Guide 2225
show system-dump
show system-dump
Description
Displays the system-dump server IP and dump-timeout.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Use this command to display configured parameters for a system dump transfer. Dump transfers
should not be initiated without the assistance of Technical Support.
Following are the fields displayed:
To specify the IP address to which a system dump is sent, use the following command:
configure system-dump server
To specify the timeout, use the following command:
configure system-dump timeout
Example
The following command displays the system-dump server IP and dump-timeout:
show system-dump
Following is the output from this command with nothing configured:
Server ip : none
Dump timeout : none
Following is the output from this command with both an IP address and timeout configured:
Server ip : 10.5.2.82 (ok)
Dump timeout : 300 seconds
Following is the output from this command with an unreachable IP address:
Server ip : 1.2.3.4 - currently unreachable via "Mgmt" vlan
Server ip Displays the IP address to which a triggered system dump is sent.
Indicates whether the server is reachable through the VLAN mgmt.
Dump timeout Displays the time in seconds until a system dump transfer is halted.
To Next Page
Loading...