Extreme Networks ExtremeWare - Enable Web

enable web
ExtremeWare Software 7.3.0 Command Reference Guide 187
enable web
enable web {access-profile [<access_profile> | none]} {port
<tcp_port_number>}
Description
Enables ExtremeWare Vista web access to the switch.
Syntax Description
Default
Enabled, using TCP port 80.
Usage Guidelines
By default, web access is enabled on the switch.
For version 6.0 and higher:
• By default, web access has no access profile and uses TCP port number 80.
• Use an access profile to restrict ExtremeWare Vista web access. An access profile permits or denies a
named list of IP addresses and subnet masks. You must create and configure an access profile before
you can use this option. You create an access profile using the
create access-profile command.
You configure an access profile using the configure access-profile command. Apply an access
profile only when ExtremeWare Vista is enabled.
• Use the none option to cancel a previously configured access-profile.
• Use the port option to specify a TCP port number.
Example
The following command applies the access profile administrators to the web:
enable web access-profile administrators
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 6.0 to include the access profile and port options.
Platform Availability
This command is available on all platforms.
access profile Specifies an access profile. (6.0, 6.1)
none Cancels a previously configured access profile. (6.0, 6.1)
port Specifies a TCP port number. (6.0, 6.1)