1326 ExtremeWare Software 7.3.0 Command Reference Guide
IGP Commands
configure rip vlan trusted-gateway
configure rip vlan [<vlan name> | all] trusted-gateway [<access profile> |
none]
Description
Configures a trusted neighbor policy, which uses an access profile to determine trusted RIP router
neighbors for the VLAN on the switch running RIP.
Syntax Description
Default
N/A.
Usage Guidelines
Using the
none
mode, the access profile can contain a combination of permit and deny entries. Each
entry must have a permit or deny attribute. The operation is compared with each entry in the list. When
a match is found, the operation is either permitted or denied, depending on the configuration of the
matched entry. If no match is found, the operation is implicitly denied.
Example
The following command configures RIP to use the access profile nointernet to determine from which RIP
neighbor to receive (or reject) the routes to the VLAN backbone:
configure rip vlan backbone trusted-gateway nointernet
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
vlan name Specifies a VLAN name.
all Specifies all VLANs.
access profile Specifies an access-profile name.
none Specifies to check the access profile for permit and deny attributes.
To Next Page
Loading...