1920 ExtremeWare Software 7.3.0 Command Reference Guide
Power Over Ethernet Commands
— Image not found—No firmware image found.
— Version mismatch—Firmware version does not match what the system expects for this particular
ExtremeWare release.
— Invalid—Firmware was corrupted. Repeat the firmware download.
Example
The following command displays inline power status for the system:
show inline-power
Following is sample output from this command:
Inline Power System Information
System maximum inline-power: 32 watts
Power Usage: 70% (22 watts)
Slot Main PSU Status Backup PSU Status Firmware Status
1 OFF Present, ACTIVATED Operational
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
To Next Page
Loading...