show ports configuration
ExtremeWare Software 7.3.0 Command Reference Guide 289
Following is the output from this command:
Port Configuration Monitor Thu Oct 24 16:22:08 2002
Port Port Link Auto Speed Duplex Flow Ld Share Media
State Status Neg Cfg Actual Cfg Actual Ctrl Master Pri Red
1:1 ENABLED R ON AUTO 1000 AUTO FULL NONE UTP
1:2 ENABLED R ON AUTO AUTO UTP
1:3 ENABLED R ON AUTO AUTO UTP
1:4 ENABLED R ON AUTO AUTO UTP
1:5 ENABLED R ON AUTO AUTO UTP
1:6 ENABLED R ON AUTO AUTO UTP
1:7 ENABLED R ON AUTO AUTO UTP
1:8 ENABLED R ON AUTO AUTO UTP
2:1 ENABLED R ON 1000 AUTO SX
2:2 ENABLED R ON 1000 AUTO
2:3 ENABLED R ON 1000 AUTO
2:4 ENABLED R ON 1000 AUTO
2:5 ENABLED R ON 1000 AUTO
2:6 ENABLED R ON 1000 AUTO
2:7 ENABLED R ON 1000 AUTO
2:8 ENABLED R ON 1000 AUTO
3:1 ENABLED R ON 1000 AUTO SX
3:1 ENABLED R ON 1000 AUTO SX
3:2 ENABLED R ON 1000 AUTO SX
3:3 ENABLED R ON 1000 AUTO SX
3:4 ENABLED R ON 1000 AUTO SX
3:5 ENABLED R ON 1000 AUTO SX
3:6 ENABLED R ON 1000 AUTO SX
3:7 ENABLED R ON 1000 AUTO SX
3:8 ENABLED R ON 1000 AUTO SX
3:9 ENABLED R ON 1000 AUTO SX
3:10 ENABLED R ON 1000 AUTO SX
3:11 ENABLED R ON 1000 AUTO SX
3:12 ENABLED R ON 1000 AUTO SX
4:1 ENABLED R ON 622 AUTO SMF
4:2 ENABLED R ON 622 AUTO SMF
5:1 ENABLED R ON AUTO AUTO UTP
5:2 ENABLED R ON AUTO AUTO UTP
5:3 ENABLED R ON AUTO AUTO UTP
5:4 ENABLED R ON AUTO AUTO UTP
================================================================================
Link Status: A-Active R-Ready D-Disabled NP-Not Present LB-Loopback
U->page up D->page down ESC->exit
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 4.0 to support modular switches.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...