configure stpd ports link-type
ExtremeWare Software 7.3.0 Command Reference Guide 1015
Example
The following command configures ports 1 through 4 to be point-to-point links in STPD s1 on a
stand-alone switch:
configure stpd s1 ports link-type point-to-point 1-4
The following command configures slot 2, ports 1 through 4 to be point-to-point links in STPD s1 on a
modular switch:
configure stpd s1 ports link-type point-to-point 2:1-2:4
History
This command was first available in ExtremeWare 7.1.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...