Extreme Networks ExtremeWare - Page 1039

show stpd ports
ExtremeWare Software 7.3.0 Command Reference Guide 1039
The following command displays the state of slot 3, ports 1 through 3 on an STPD named s0 on a
modular switch:
show stpd S0 ports 3:1-3:3
The results for this command are as follows:
* Alpine3804:4 # show stpd s0 ports 3:1-3:3
Port Mode State Cost Flags Priority Port ID Designated Bridge
3:1 802.1D FORWARDING 100 e------- 16 16641 00:00:00:00:00:00:00:00
3:2 802.1D FORWARDING 100 e------- 16 16642 00:00:00:00:00:00:00:00
3:3 802.1D FORWARDING 100 e------- 16 16643 00:00:00:00:00:00:00:00
Total Ports: 14
------------------------- Flags: ----------------------------
1: e=Enable, d=Disable
2: L = Loopback port
3: (Port role) R=Root, D=Designated, A=Alternate, B=Backup
4: (Config type) b=broadcast, p=point-to-point, e=edge, a=auto
5: (Oper. type) b=broadcast, p=point-to-point, e=edge
6: p=proposing, a=agree
7: (partner mode) d = 802.1d, w = 802.1w
8: i = edgeport inconsistency
History
This command was first available in ExtremeWare 2.0.
Support for modular switches was introduced in ExtremeWare 4.0.
Support for the all keyword was introduced in ExtremeWare 4.0.
Support for the detail keyword was introduced in ExtremeWare 6.2 and replaced the all keyword.
Support for displaying RSTP data was introduced in ExtremeWare 7.1.
Platform Availability
This command is available on all platforms.