Extreme Networks ExtremeWare User Manual

show esrp
ExtremeWare Software 7.3.0 Command Reference Guide 1119
No-count ports on the System:
The following command displays detailed ESRP status information for the VLANs on the switch:
show esrp detail
It produces output similar to the following:
VLAN Interface(Layer 2): demo_esrp
Priority: 0 (Priority In Use: 0)
Active Ports: 2
Internal Ports: 0
Tracked Rt/Ping/LSP: 0
Tracked Ports: 0
Tracked Diag: -
Tracked Env: -
Tracked RIP: -
Tracked OSPF: -
Tracked BGP: -
Tracked LSP: None
ELRP in Premaster(Int, Cnt):Enabled(1, 3)
ELRP in Master(Int): Enabled(1)
Election Algorithm: ports-track-priority-mac
Group: 0
Hello Timer: 2
Esrp Nbr Timeout: 6
Premaster Timeout: 6
State: Enabled(Slave) on Mon Jun 2 10:09:48 2003
State Trans Counters: ToMaster:(1) ToPremaster:(1) ToSlave:(2)
Host (Direct-Attach) ports : None
No-count ports: None
Restart Ports: None
Tracked VLANs: None
Tracked Ip Routes: None
Tracked Pings/Freq/N_miss:
192.12.1.1/5/2*
Neighbours:
[1] Nbr Active Ports: 3
Nbr Internal Ports: 0
Nbr Tracked Rt/Ping/LSP: 0
Nbr Tracked Ports: 0
Nbr Priority: 0
Nbr MacID: 00:01:30:33:28:00
Nbr HelloTimer: 2
Nbr ESRP State: Master
History
This command was first available in ExtremeWare 4.0.
This command was updated to support ELRP data in ExtremeWare 6.2.2b134 and ExtremeWare 7.1.0.
ELRP data is not displayed in ExtremeWare 7.0.
This command was updated to support ESRP hitless failover statistics in ExtremeWare 7.1.1.

Extreme Networks ExtremeWare Specifications

General

Brand	Extreme Networks
Model	ExtremeWare
Category	Software
Language	English