show ipconfig
ExtremeWare Software 7.3.0 Command Reference Guide 1241
The following example shows global output for the
show ipconfig
command:
show ipconfig
Following is sample output from this command:
Router Interface[1] on VLAN test is enable and up.
UDP Forwarding profile: none.
inet 11.3.3.4 netmask 0xffffff00 broadcast 11.3.3.255
Secondary: inet 11.4.3.4 netmask 0xffffff00 broadcast 11.4.3.255
Multicast ttl 1 metric 1 mtu 1500
Locally registered multicast address (Last Querier=11.3.3.4):
224.0.0.1
Flags:
AddrMaskRly NO BOOTP Host NO DirBcstHwFwd NO DVMRP NO
ESRP NO Fwd Bcast NO IGMP YES IGMP Ver V2
IgnoreBcast NO IP Fwding NO IPmc Fwd NO IRDP Advert NO
ISIS NO ISQ NO LDP NO LPM-routing NO
MPLS NO NAT-Inside NO NAT-Outside NO OSPF NO
PIM NO RIP NO RSVP NO SendParam YES
SendPortUn YES Send Redir YES SendTimxceed YES SendUnreach YES
SLB-Cli NO SLB-Srv NO SubVLAN Prxy YES TimeStampRly NO
VRRP NO
History
This command was first available in ExtremeWare 2.0.
This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare
v6.1.8b12 to support MPLS modules.
The output for this command was changed to accommodate the multinetting feature by including
secondary IP addresses. This modified command was made available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...