Extreme Networks ExtremeWare - Page 1475

show bgp neighbor
ExtremeWare Software 7.3.0 Command Reference Guide 1475
Example
The following command displays information about a specified neighbor:
show bgp neighbor 10.10.10.10
Following is the output from this command:
IBGP Peer: 10.10.10.10 As: 14490 Enabled: Yes Router: Enabled Weight: 1
ConnectRetry: 120 HoldTimeCfg: 180 KeepaliveCfg: 60 MinAsOrig:15
Source Interface: Not configured RRClient: No EBGP-Multihop: No
NextHopSelf: Enabled Send Communities: No Soft Input Reconfiguration: Disabled
Max-Prefix: 100000 Threshold: 75 Teardown: Yes(HoldInt: 300) SendTraps: No
Remove Private AS : No
IN NLRI Filter : None
OUT NLRI Filter : None
IN AS-Path Filter : None
OUT AS-Path Filter : None
IN ROUTE-MAP : None
OUT ROUTE-MAP : None
State: IDLE(Reached maximum prefix limit)
RemoteAddr:10.10.10.10:179 LocalAddr:10.10.10.51:1024 PeerRtrId:0.0.0.0
InUpdates: 26549 OutUpdates(InQ): 0(0) InTotalMsgs: 26559 OutTotalMsgs: 9
InUpdateElapsedTime: 0:0:00:20 InMsgElapsedTime: 0:0:00:20 InPrefix: 0
HoldTime: 180 KeepAlive: 60 FsmTransitions: 1 RestartAfter: 0:04:43
FSM Down since: Mon Apr 1 15:59:42 2002 (Duration: 0:0:00:17)
LastErr: 0/0
History
This command was available in ExtremeWare 6.1.
This command was modified in ExtremeWare 6.2.2 to include information about maximum prefix
settings.
This command was modified in ExtremeWare 7.0.0 to show flap statistics and suppressed routes for
BGP route flap dampening.
Platform Availability
This command is available on all platforms.