1652 ExtremeWare Software 7.3.0 Command Reference Guide
PoS Commands
routed IP traffic (because IPCP imposes less header overhead, the maximum link throughput is higher
than with BCP).
Example
The following command example configures BCP on the PPP port, and applies to a PoS module
installed in slot 1 of a BlackDiamond switch:
configure ppp bcp off port 1:4
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only. A similar command is available on the
Alpine switch.
To Next Page
Loading...