configure mpls rsvp-te vlan
ExtremeWare Software 7.3.0 Command Reference Guide 1805
messages are sent. The
summary-refresh-time
value may be set to any value between zero to 100 (or
10 seconds).
If configured, the bundled and summary refresh RSVP messages are only sent to RSVP-TE peers
supporting RSVP refresh reduction.
Example
The following command configures the rsvp-te interface parameters for VLAN vlan1.
configure mpls rsvp-te vlan vlan1 hello-interval 2 refresh-time 5
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
To Next Page
Loading...