Extreme Networks ExtremeWare - Page 292

292 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Configuring Slots and Ports on a Switch
Flags: (a) Load Sharing Algorithm address-based, (d) DLCS Enabled
(D) Port Disabled, (dy) Dynamic Load Sharing
(e) Extreme Discovery Protocol Enabled, (E) Port Enabled
(f) Flooding Enabled, (g) Egress TOS Enabled, (G) SLB GoGo Mode
(h) Hardware Redundant Phy, (j) Jumbo Frame Enabled
(l) Load Sharing Enabled, (m) MAC Learning Enabled
(n) Ingress TOS Enabled, (o) Dot1p Vlan Priority Replacement Enabled
(p) Load Sharing Algorithm port-based, (P) Software Primary Port
(q) Background QOS Monitoring Enabled
(r) Load Sharing Algorithm round-robin, (R) Software Redundant Port
Diag: (P) Passed, (F) Failed
Port: (iL) Internal Loopback
The following command displays more specific information for slot 2, port 6 in a modular switch:
show ports 2:6 info detail
Following is sample output from this command:
Port 2:6:
Type: UTP
Diagnostic: passed
Random Early Drop: Disabled
Admin state: Enabled, with auto-duplex auto-speed sensing
Link state: Ready
Link counter: Up 0 time(s), Down 0 times(s)
VLAN cfg:
Default [Internal Tag=0001,Mac-Limit:Cfg=No-limit,LRN=0,BlkHole=0]
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Aggregate B/W: Configured [ 25]%
Trunking: Load sharing is not enabled
Protocol: VLAN=Default Vpri=0 Protocol=ANY [EtherType:ffff]
EDP: enabled
DLCS: disabled
lbdetect: disabled
Learning: enabled
Flooding: disabled
Jumbo: Disabled
BG QoS monitor: disabled
Ingress Rate Shaping:
QoS profile: None configured
Queue: Q0 using QP1 MinBw=0% MaxBw=100% Pri=0.
Q1 using QP2 MinBw=0% MaxBw=100% Pri=1.
Q2 using QP3 MinBw=0% MaxBw=100% Pri=2.
Q3 using QP4 MinBw=0% MaxBw=100% Pri=3.
Q4 using QP5 MinBw=0% MaxBw=100% Pri=4.
Q5 using QP6 MinBw=0% MaxBw=100% Pri=5.
Q6 using QP7 MinBw=0% MaxBw=100% Pri=6.
Q7 using QP8 MinBw=0% MaxBw=100% Pri=7.
Ingress IPTOS: Examination is disabled
IPTOS->QOSProfile mapping:
00->QP1 01->QP1 02->QP1 03->QP1 04->QP1 05->QP1 06->QP1 07->QP1