show fdb
ExtremeWare Software 7.3.0 Command Reference Guide 375
Total: 33 Static: 16 Perm: 0 Locked: 0 Secure: 0 Dynamic: 17 Dropped: 0
Questionable: 0 Remapped: 0
FDB Aging time: 300 seconds
The following command displays information about the permanent entries in the FDB:
show fdb permanent
It produces output similar to the following:
EQP IQP Index Mac Vlan Flags Port List
--------------------------------------------------------------------------------
QP3 QP2 ----- --- 00:10:E3:1D:00:05 anntest1(4094) pm ---
QP3 QP2 4e610-206 00:01:03:2F:38:EE anntest1(4094) spm ---
QP3 QP2 ----- --- 00:60:B0:F9:58:9D Default(0001) pm ---
Flags: (B) Egress Blackhole, (b) Ingress Blackhole, (d) Dynamic, (s) Static
(p) Permanent, (m) MAC, (S) secure MAC, (l) lockdown MAC, (M) Mirror
(i) IP, (x) IPX, (z) translation MAC, (Q) Questionable, (R) Remapped
[ ] : authorize port list
Total: 3 Secure: 0
History
This command was available in ExtremeWare 2.0.
This command was modified in ExtremeWare 6.2.1 to support the
broadcast-mac
option.
This command was modified in ExtremeWare 6.2.2b108 to support the
remap
option.
The
remap
option was not supported in ExtremeWare 7.0.
This
remap
option is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...