configure slb pool add
ExtremeWare Software 7.3.0 Command Reference Guide 499
configure the ratio, use the smallest common denominator. For example, to configure a ratio of 25% and
75%, use ratios of 1 and 3, instead of 25 and 75.
To configure a pool to use the ratio load balancing method, use the following command:
configure slb pool <pool name> lb-method ratio
Higher priority numbers indicate higher priority. To configure a pool to use the priority load balancing
method, use the following command:
configure slb pool <pool name> lb-method priority
To change the ratio or priority of a node that is already in a pool, use the following command:
configure slb pool <pool name> member
Example
The following command adds the FTP node with an IP address of 10.2.1.2 to the pool “ftp” and
configures the node with a priority of 2:
configure slb pool ftp add 10.2.1.2 : ftp priority 2
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...