ExtremeWare Software 7.3.0 Command Reference Guide 59
1 Command Reference Overview
Introduction
This guide provides details of the command syntax for all ExtremeWare commands as of
ExtremeWare version 7.3.0.
NOTE
ExtremeWare 7.3.0 only supports Extreme Networks products that contain the “i” or “3” series chipset.
This includes the BlackDiamond, Alpine, and Summit “i” series platforms, but does not include the
Summit e-series and Summit 200 series platforms.
This guide does not provide feature descriptions, explanations of the technologies, or configuration
examples. For information about the various features and technologies supported by Extreme Networks
switches, see the installation and user guides for your product. This guide does not replace the
installation and user guides; this guide supplements the installation and user guides.
Audience
This guide is intended for use by network administrators who are responsible for installing and setting
up network equipment. It assumes a basic working knowledge of the following:
• Local area networks (LANs)
• Ethernet concepts
• Ethernet switching and bridging concepts
• Routing concepts
• Internet Protocol (IP) concepts
• Routing Information Protocol (RIP) and Open Shortest Path First (OSPF) concepts
• Border Gateway Protocol (BGP-4) concepts
• IP Multicast concepts
• Distance Vector Multicast Routing Protocol (DVMRP) concepts
• Protocol Independent Multicast (PIM) concepts
• Internet Packet Exchange (IPX) concepts
To Next Page
Loading...